Individual Digit Brightness Setting#

Added in version r8.02.

Note

This menu item may not be available to all users. Its availability can vary depending on device configuration.

This menu item may be available for all users in future versions.

Menu navigation

Menu:: SYSt
Item:: c7
Values:: submenu di

This setting allows you to adjust the brightness of individual digits. Each digit is adjusted separately, with values ranging from values 0 to E (values 0–9, then values A–E). This is useful in cases where certain digits are brighter than other, and you need to balance their brightness.

Proceed to enter the submenu di by pressing PB2L or OK on IR remote controller:

Submenu `di`#
Value	Description	Range
`˙00.:00.` `˙00.:00. ⁰⁰⋅` `˙00.:00.:00.`	Setting of display brightness of individual digits (set value is blinking)	`0`–`E`

Settings Procedure#

Enter the submenu di by pressing PB2L or OK on IR remote controller. The first digit is blinking.
Set your desired brightness ranging from 0 (no change to brightness) to E (maximal brightness reduction):
- To increase the set value (increase brightness reduction), press the PB2 button or + button on IR remote controller.
- To descrease the set value, press the PB1 button or – button on IR remote controller.
If you are satisfied with the set brightness, press the PB2L or OK on IR remote controller to move to next digit. The next digit is blinking. Repeat the procedure.
If you are satisfied with the brightness of all digits, press the the PB2L or OK on IR remote controller until the end. It will automaticaly save the set values and return to SYSt menu item c7:di.