Werking van niet-netwerkklok#
Afhankelijk van de synchronisatiebron moet de DIP-schakelaar op de klokprint worden geconfigureerd - in de DCF-stand of in de LINES-stand (standaardinstelling). De positie van de DIP-schakelaar staat onder de letter B op de PCB-diagrammen.
Pas op
De juiste stand van de DIP-schakelaar moet worden ingesteld voordat de lijnbedrading wordt aangesloten op de LINES-connector of voordat de synchronisatielijn wordt gestart.
Ga naar SYNC-menu optie o2 (Type synchronisatie) en stel het gewenste type in. De automatische detectie (o2: A) is van toepassing op DCF-signalen, MOBATIME seriële code, IRIG-B.
De permanent oplichtende dubbele punt tijdens de tijdweergave geeft aan dat de klok wordt gesynchroniseerd door de synchronisatiebron.
Inhoud#
Synchronisatie via DCF 77 Ontvanger
Synchronisatie via GPS-ontvanger
Synchronisatie via GPS ontvanger (GNSS 4500)
Synchronisatie via impulsen
Synchronisatie via MOBATIME seriële code, MOBALine of IRIG-B
Aansturing door IF482 via RS-485