Classic Striking on the Bells or Dulcimers

This function is used to set the parameters and type of ringing on bells or dulcimers using electric bell strikers. Switching of electric hammers is realized by means of additional module HN…SSR2. By default, striking is disabled.

When activated, the display shows following:

Strike off22-05h
1/2 I02 P18 Ph10

off22-05h:

Striking off period

1/2:

Striking type

I02:

Impulse length

P18:

Gap length

Ph10:

Gap length between 1/4 and hour striking at 1/4 striking type

Button function in ‘item edit’ mode

< >:

Move between items

+ -:

Switch flasing item (holding down the button will cycle through the options)

v:

Save edited values and return to page view

x:

Exit without save and return to page view

Striking Types

You can set following striking types:

1/4:

Output 1 is always activated at the 15^th, 30^th, 45^th and 00^th minute

Output 2 is activated at the full hour with the number of hour strikes

1/2:

Output 1 is always activated on 30^th minute (1 strike) and on the full hour with the number of hour strikes

1/1:

Output 1 is always activated at the full hour with the number of hour strikes

1/0:

Output 1 is always activated at the full hour (1 strike)

Number of strikes / Output

Striking type	15th minute	30th minute	45th minute	60th minute	full hour
1/4 [1]	1 / OUT 1	2 / OUT 1	3 / OUT 1	4 / OUT 1	1–12 / OUT 2
1/2	–	1 / OUT 1	–		1–12 / OUT 1
1/1	–				1–12 / OUT 2
1/0	–			1 / OUT 1	–

---

[1]

When striking every quarter of an hour, it usually rings a quarter of an hour on bell with a higher tone and full hours on bell with a lower tone.