Digital Clock Settings

1. Enter the digital clock main menu, navigate to the SENx submenu and proceed to enter.

2. Navigate to item t1 and check whether the value is set to 0.

3. The digital clock will display the measured temperature within about 20 seconds after connection.

Temperature Correction

Temperature sensors may have inherent inaccuracies or drift over time. If this is the case, you can set the temperature correction on display by following this procedure:

1. Enter the digital clock main menu, navigate to the SENx submenu and proceed to enter.

2. Navigate to item t2 and proceed to enter the item which leads to submenu cT where the -d.d is displayed.

Submenu cT

Value	Range
–d.d	– = negative value d.d = value of correction set digit by digit, the range of each digit is 0–9 range: -9.9 to 9.9 °C

3. Enter the edit mode of -d.d value:

   1. First digit will flash. You can then set the negative (–) or positive value. Confirm your selection and move to next value d.

   2. Second digit will flash. You can then set the numerical value in range 0–9. Confirm your selection and move to next value .d

   3. Third digit will flash. You can then set the decimal value in range 0–9. Confirm your selection to save end exit edit mode.