Sensor Settings#

IP Address Change#

Changing the IP address is done using the EthernetConfigurator software.

Click here to download the EthernetConfigurator software

https://cdn.papouch.com/data/user-content/old_eshop/files_article/Ethernet_Configurator/ethernet-configurator.zip

  1. After starting the software, all temperature sensors connected to the local LAN are found and their IP addresses are displayed in the upper window.

  2. Select the IP of the temperature sensor you want to set and pres the Set Device button.

  3. At the bottom, edit the IP address and possibly other parameters.

  4. Press the Set button to send the current setting to the temperature sensor.

Reset#

Use the following procedure to reset the device to its factory settings:

TP LAN with hole located under Ethernet connector#

  1. Disconnect power.

  2. Press and hold the button in the hole under the Ethernet connector.

  3. Turn on power and wait approx. 10 seconds.

  4. Release the button.

  5. The device reset process is complete.

TP LAN without hole located under Ethernet connector#

  1. Disconnect power.

  2. Open the device box by unsrewing screws on the sides.

  3. Short the jumper inside the device and keep it shorted.

  4. Turn on power and wait approx. 10 seconds.

  5. Disconnect the jumper and reassemble the box.

  6. The device reset process is complete.

TP LAN PoE#

  1. Disconnect the Ethernet cable.

  2. Pres and hold the reset button.

  3. Connect the Ethernet cable.

  4. Release the reset button.

  5. The device reset process is complete.

On this page