Power SAVE#

Menu navigation

Menu:: Powr
Item:: P2
Values:: 0, 1

An automatic mode where the clock display is switched off at set time interval. If one of the push-buttons or the IR remote controller is pressed, the display is briefly switched on. At this time the clock can be operated normally.

After 10 seconds have elapsed since the last press of the button or push-button, the clock display will switch off again.

Entry into this mode is indicated by the display of SLP for 1 second.

Activation of Power save mode:

Value(s)	Description
`0`	Power save mode disabled
`1`	Power save mode enabled

Alternatively, activation can be done via Web interface tab Mode.

../../_images/web-interface-mode-power-save.png

Note

Following start and end time submenus are accessible only if the Power save mode is activated.

Save mode start time#

Menu navigation

Menu:: Powr
Item:: P3
Values:: St* (accessible submenu)

The Save mode start time can be set by this submenu:

Value(s)	Description	Range
`HH`	Setting of hour	Range 0–23
`MM`	Setting of minutes	Range 0–59

Save mode end time#

Menu navigation

Menu:: Powr
Item:: P4
Values:: Ed* (accessible submenu)

The Save mode end time can be set by this submenu:

Value(s)	Description	Range
`HH`	Setting of hour	Range 0–23
`MM`	Setting of minutes	Range 0–59