GPS Receiver (GNSS 4500)#

  1. Configure the DIP switch to DCF positon.

    See also

    To configure DIP switch position, you need to dismount the front plexiglass. See Cable connection chapter.

    ../../_images/dip-dcf.svg ../../_images/dip-dcf-dark.svg

    Note

    It is important to switch both positions to ON (DCF).

  2. Set value A in SYNC menu items o1 (Timezone of Synchronization Source) and o2 (Type of Synchronization). Set your desired time zone in dISP menu item d2 (Time Zone of Time and Date).

  3. Connect GPS receiver (GNSS 4500) to the LINES IN connector on back side of the recess. Connect yellow and green cable to external power supply.

    Attention

    Please note the correct polarity of the wires – see the GPS user manual.

    ../../_images/gnss4500-eco-dc.svg ../../_images/gnss4500-eco-dc-dark.svg

  4. For the correct placing of the receiver please follow the GPS user manual.

  5. Presuming the good position of the GPS receiver (GNSS 4500) the synchronization takes place in approx. 10 to 20 minutes. The green LED diode lights up.