Standard Mode

After activation, the standard screen is displayed and the terminal is ready for use.

To record, simply attach the RDIF medium or finger or enter a PIN (depending on terminal variant). The record type (arrival or departure) is calculated automatically. Balance information and details of employee personal attendance can be found in the employee menu.

Arrival / Departure

Identification by RFID Medium

See also

How to assign a chip (RFID medium) to an employee can be found in chapter How to Assign a Chip to an Employee via the Terminal.

To record arrival / departure, simply attach the RFID identification medium to the area below the display marked with horizontal lines.

You can also enter a specific event on terminal. Simply select the desired icon (arrival, departure, break, business trip, etc.) before attaching the medium.

Once the employee is identified, the event is sent to the server.

Identification by PIN Code

See also

How to assign a PIN code can be found in chapter How to Set Up an Employee PIN via the Terminal.

To record arrival/departure, enter the PIN on the numeric keypad on the right of the screen.

Fingerprint Identification

Note

Only for terminal with a fingerprint scanner (FPC).

Place your finger on the fingerprint reader without much pressure. Your finger must cover the reader.

If the fingerprint is detected when the finger is attached, a beep will sound. If the reader does not recognize the fingerprint, no sound will be heard.

The fingerprint is on the same level as the RFID card, it behaves the same in the system. The cloud application can then distinguish whether the card or the fingerprint has been used.

See also

How to upload a fingerprint can be found in chapter How to Upload a Fingerprint.