Wall Mounting#

DSC.180–DSC.320#

Step 1

../../../_images/dsc-single-wall-1.svg

  • Assemble the wall mounting console if delivered disassembled.

  • Drill at least four anchoring holes into the wall of a diameter adequate to appropriate screws.

    1

    Use the mounting console as a template.

Step 2

../../../_images/dsc-single-wall-2.svg

  • Mount the console on the wall.

Step 3

../../../_images/dsc-single-wall-3.svg

  • Unscrew the tilt-lock screws on the sides.

  • Put the console into a fully tilted out position.

Step 4

../../../_images/dsc-single-wall-4.svg

  • Hang the clock unit into the flipped out console arms and fix it by tightening the screws.

Step 5

../../../_images/dsc-single-wall-5.svg

  • Dismantle the back cover of connectors on the clock unit body. The cover incorporates gap with sealing for passage of cables in the inside of the clock unit.

Step 6

../../../_images/dsc-single-wall-6.svg

  • Arrange all incoming cables to appropriate length and connect them to the appropriate terminals on the PCB. See the description of the connectors.

    Caution

    Observe the correct polarity where necessary.

    Caution

    For LGC variant, configure the position of DIP switch according to used synchronization signal (applies only for DCF, MOBALine, polarized impulse line or IRIG‑B).

    Navigate to Clock Operation chapter > Non-Network Clock Operation chapter to get detailed info about connection of various synchronization sources and receivers.

  • Fix the cables with the holder in correct positions in order to maintain regular spacing between the cables in the area of passing through sealing. Use appropriate force to not to damage the cables insulation.

Step 7

../../../_images/dsc-single-wall-7.svg

  • Mount back the connector cover.

Step 8

../../../_images/dsc-single-wall-9.svg

  • Tilt the clock unit into vertical position and fix the position of the console.

DSC.500#

TBA

On this page